Call 02 6962 1184

Government

Advantages of using our products for all your Government needs:

Ability to install rows of pipes/box culverts parallel maintaining a low profile.
Helps to unify multi-cell structures together.
Can be used to keep soil back to prevent erosion.
Special requirements where a higher than usual headwall is necessary can be manufactured to order.

Can be used to keep soil back to prevent erosion.
Headwalls to suit 30cm x 15cm x 2.5m Box Culverts to 4.2m x 4.2m x 1.2m Box Culverts
No need for on site frame work.

Box Culverts are used in irrigation, drainage and bridge works for domestic and government projects.
This product allows for a larger more natural water flow reducing erosion and can be laid with no cover needed.
Ability to be inverted for ease of cleaning and maintenance.
Designed to take extreme loads of pressure and any highway vehicle axle load permitted by the Roads & Maritime Services.
Available in Over 120 different sizes.
Manufactured to AS 1597.1-2010 & AS 1597.2 2013
Dimensions may vary, please contact B.Altin & Co for confirmation.

Minimises hazard on shoulder of roads without compromising the batter of the soil.
Generally used by Roads & Maritime Services and Shire Councils across Australia.
Sizes range to suit 300mm to 525mm inside diameter pipes.

Minimises hazard on shoulder of roads without compromising the batter of the soil.
Generally used by Roads & Maritime Services and Shire Councils across Australia.
Sizes range to suit 300mm to 600mm inside diameter pipes.

Wide range of sizes are manufactured to fit from 150mm to 1800mm inside diameter pipes.
Can be used to eradicate erosion in a lift pump situation.
Frequently used in access crossings, subdivisions and road works.
Also available in full neoprene to give a water tight seal able to take a steel door.
Available with step for board control allows overflow to maintain you channel water level.
New design has a self cleaning groove to remove debris from door slide.
Easy pipe installation with either a rubber ring or emer seal eliminating the need for any grouting.
Multi-cell headwalls available to order.
Quick lift & A-Frame systems available to suit.

Quality reinforced flanged pipe for irrigation.
Rubber ring coupling gives flexibility to eliminate joint cracks.
Allows for ground movement after Installation.
Available in strength classes made to suit you irrigation needs.
Manufactured to AS/NZS 4058:2007 Pre-cast concrete pipes (pressure & non-pressure) standards.

Typically used in conjunction with a pipe headwall and rubber ring joint pipe.
Used for irrigation needs; supply drainage, sumps & crossings.
Available in strength classes made to suit you irrigation needs.
Manufactured to AS/NZS 4058:2007 Pre-cast concrete pipes (pressure & non-pressure) standards.

For more information contact our office and speak to our staff on 02 6962 118.